DrillSaw Highspeed 200™ User’s Guide
DFU-0225-2 Rev. 0 Page 16 of 58
The maximum rotational speed of the DrillSaw Mini 300 attachments stated in
the User’s Guide DFU-0223-XX can only be reached when the AR-200M motor
speed is set to 15,000 rpm on the AR-200C console.
Rotational energy: Fast deceleration of the bur can cause the selected torque to be
overloaded as a result of the rotational energy stored in the drive system.
AR-200M-ISO:
Only use ISO saw attachments that are listed in this User’s Guide as official
DrillSaw Highspeed 200 accessories.
These ISO saw attachments provide their own User’s Guide.
Coupling system according to ISO 3964 / DIN 13940
Please refer to the device specific User’s Guide and safety notes
for more information about the ISO saw attachments that can be
connected to the AR-200M-ISO motor.
To prevent the ISO saw attachments from turning during transmission of high
torques, the locking pin supplied can be pushed into the designated hole. See
Figure 6.
Figure 6 AR-200M-ISO Motor with ISO Saw Attachment Coupling
Table 6 AR-200M-ISO Motor Elements
21
22
23
To Next Page
Loading...
General