DrillSaw Highspeed 200™ User’s Guide
DFU-0225-2 Rev. 0 Page 54 of 58
14 Electromagnetic Emissions
Table 22 Guidance and Manufacturer's Declaration - Electromagnetic
Emissions
The DrillSaw Highspeed 200 is intended for use in the electromagnetic environment
specified below. The customer or the user of the DrillSaw Highspeed 200 should ensure
that it is used in such an environment.
Electromagnetic Environment – Guidance
RF emissions
CISPR 11
Group 1
The DrillSaw Highspeed 200 uses RF energy only for
its internal function. Therefore its RF emissions are
very low and not likely to cause any interference
with nearby electronic equipment.
The DrillSaw Highspeed 200 is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage power
supply network that supplies buildings used for
domestic purposes.
emissions
N/A
fluctuations/
flicker emissions
N/A
Table 23 System Cables
Power Cords
Supply line power to the
console
No No 3.1 m (10 ft.)
To Next Page
Loading...
General