ASCOM D81 Configuration Manual

TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
55
5. Handset Configuration
6 Select System Profiles > System Profiles Sub Groups > Alarm settings group > Alarm
settings X > No-movement and Man-down.
• Man-down alarm - Determines if the Man-down alarm is enabled or disabled.
• Man-down detection time - Determines when the warning phase starts after
man-down is triggered.
• No-movement alarm - Determines if the No-movement alarm is enabled or
disabled.
• No-movement detection time - Determines when the warning phase starts after
No-movement alarm is triggered.
• Warning phase duration - Determines the time before the warning phase is ended
and the alarm is sent.
• ALS - Determines if a ramped up signal shall sound after an alarm is sent. Note: If
the handset is configured to call a predefined number when an alarm is sent (see
5.26 Common Alarm Settings on page 37), the ALS is not triggered.
7 Select System Profiles > System Profiles Sub Groups > Alarm settings group > Alarm
settings X > Pull-cord
• Pull-cord alarm - Determines if the pull-cord alarm is enabled or disabled.
• ALS - Determines if a ramped up signal shall sound after an alarm is sent. Note: If
the handset is configured to call a predefined number when an alarm is sent (see
5.26 Common Alarm Settings on page 37), the ALS is not triggered.
Configure Sound and Alerts Sub Group
These parameters let the system administrator define up to five different system profile sub
groups of sounds and alerts. To configure a sub group:
1 Select System Profiles > System Profiles Sub Groups > Sound and Alerts group >
Sound and alerts X.
2In the Name of group field, either accept the default name Group X or enter a
description appropriate to this particular sub group of sounds and alerts.
3 From the pull down menus associated with each parameter, select the required
values for:
Ring volume: Select "Silent" or one of the volume levels between 1 (lowest) and 8
(highest).
Vibrating alert: Select "On" or "Off".
Internal call: A ringtone to indicate an internal call.
External call: A ringtone to indicate an external calls.
Callback: A ringtone to indicate a callback.
PTT Call: A ringtone to indicate a Push-to-talk call.
Key sound: Select "Silent" or associate the key press with a "Click" or "Tone".
Message alert: Indicate an incoming message by a melody, beeps or a customized
sound.
Message volume: For an incoming message, set the alert to the same volume level as
for Ring volume or set a higher or lower volume.
Configure Soft key groups (sub group)
Select System Profiles > System Profiles Sub Groups > Soft key groups > Soft key group X >
Soft key X.
• Soft key label - Determines the name to be displayed on the soft key
• Function - Determines the function to be connected to the soft key.

ASCOM D81 Specifications

General

Brand	ASCOM
Model	D81
Category	Handsets
Language	English