AC08 and AC12 Operations Manual....
17
5.2 ELECTRICAL INSTALLATION, cont.
5.2.1 Input Power Connections
The converters are supplied with compression type terminal blocks for input power connections.
These terminal blocks accept wires in the range of 6-10AWG. Refer to the applicable standard for
selection of required wire gauge and type.
Prepare the power cable by removing the outer cable insulation approximately 6” (in the case of SO
type portable cables). Strip the insulation back exposing ½” of bare conductor on all three wires.
Insert the prepared cable and strain relief assembly into the rearmost hole in the input service panel.
Follow the wire table in the illustration below for correct termination.
The input to the converters is fully isolated with no phase orientation requirements to the input
power service.
To Next Page
Loading...
