AC08 and AC12 Operations Manual....
24
6.2 AUTO-RESTART FEATURE
The Auto-Restart feature will safely and automatically bring the shore power converter back on-line
following a power failure and recovery event. Highlights include:
Automatically routes power from the dock to the ships power buss.
Front panel controls allow auto-restart to be enabled or disabled.
Auto-Restart status displayed on the LCD STATUS screen.
Fault tolerant to guarantee safe operation.
Valid shore power verified prior to restart
Handles repeated power failures without operator intervention.
LETHAL VOLTAGES ARE AUTOMATICALLY ROUTED WITHIN THE
CONVERTER WHEN (1) INPUT POWER IS PRESENT, (2)THE DISCONNECT
SWITCH IS IN THE “ON” POSITION, AND (3) AUTO-RESTART IS ENABLED.
LETHAL VOLTAGES WILL BE AUTOMATICALLY ROUTED TO THE
CONVERTER OUTPUT AND THE OUTPUT CONTACTOR WILL
AUTOMATICALLY CLOSE WHEN (1) INPUT POWER IS PRESENT, (2)THE
DISCONNECT SWITCH IS IN THE “ON” POSITION, AND (3) AUTO-RESTART IS
ENABLED.
NEVER REMOVE ANY PANELS OR COVERS WITHOUT SECURING
(REMOVING) SHORE POWER WHEN AUTO-RESTART IS ENABLED.
NEVER PERFORM MAINTENANCE OR SERVICE WHILE AUTO-RESTART IS
ENABLED.
NEVER ASSUME AUTO-RESTART IS DISABLED.
NEVER USER THE DISCONNECT SWITCH TO TURN THE CONVERTER OFF
WITH AUTO-RESTART ENABLED. THE CONVERTER CANNOT DISTINGUISH
BETWEEN A VALID POWER FAILURE AND IMPROPER USE OF THE
DISCONNECT SWITCH.
To Next Page
Loading...
