AC08 and AC12 Operations Manual....
19
5.2 ELECTRICAL INSTALLATION, cont.
5.2.2 Output Power Connections
The converters area supplied with compression type terminal blocks for output power connections.
These terminal blocks accept wires in the range of 6-10AWG. Refer to the applicable standard for
selection of the required wire gauge and type. Please refer to the diagram on the previous page for
additional detail.
Prepare the power cable by removing the outer cable insulation approximately 6” (in the case of SO
type portable cables). Strip the insulation back exposing ½” of bare conductor on all three
conductors. Insert the prepared cable and strain relief assembly into the forward hole in the input
service panel. Insert the wire ends into the output terminal block and tighten.
Replace the lower front panel using the removed hardware.
To Next Page
Loading...
