AC08 and AC12 Operations Manual....
7
THIS EQUIPMENT CONTAINS HIGH ENERGY, LOW IMPEDANCE
CIRCUITS! LETHAL POTENTIALS ARE CONTAINED WITHIN
THE SYSTEM EVEN WHEN IT IS APPARENTLY NOT
OPERATING.
CARE MUST BE EXERCISED WHEN SERVICING THIS
EQUIPMENT IN ORDER TO PREVENT SERIOUS OPERATOR
INJURY OR EQUIPMENT DAMAGE.
DO NOT WORK ON OR OPERATE THIS EQUIPMENT UNLESS
YOU ARE FULLY QUALIFIED TO DO SO. NEVER WORK ALONE.
THE EQUIPMENT IS NOT IGNITION RATED, IT MUST NOT BE
OPERATED IN AREAS WHERE COMBUSTIBLE GASES MAY
ACCUMULATE.
DO NOT REMOVE THE SHORE CORD FROM THE DOCK
PEDESTAL WITHOUT FIRST OPENING THE DOCK OR YACHT
BREAKER. FAILURE TO DO SO MAY RESULT IN DAMAGE TO
THE CONVERTER AND PEDESTAL.
OBSERVE THE FOLLOWING WHEN SERVICE AND
MAINTENANCE ARE REQUIRED:
REMOVE ALL JEWELRY FROM ARMS AND NECK WHEN
SERVICING THIS EQUIPMENT. THIS PREVENTS THE
POSSIBILITY OF SHORTING THROUGH THE JEWELRY TO OR
ELECTROCUTION OF THE OPERATOR.
WEAR SAFETY GLASSES WHEN SERVICING THIS EQUIPMENT TO
PREVENT EYE INJURY DUE TO FLYING PARTICLES CAUSED BY
ACCIDENTAL SHORT CIRCUIT CONDITIONS.
DO NOT REMOVE ANY PANELS OR COVERS WITHOUT FIRST
OPENING ALL CIRCUIT BREAKERS AND THEN REMOVING THE
INPUT SERVICE.
SERVICE OTHER THAN CLEANING AIR INTAKES AND EXHAUST
AREAS SHOULD BE REFERRED TO PERSONNEL AUTHORIZED BY
THE FACTORY TO SERVICE THIS EQUIPMENT.
To Next Page
Loading...
