Ashida ADR141A - Menu Navigation and Operation

ADR141A /
ADR241A
Doc
ID
: ADR241A
_IM_01
Ref ID : ADR241A/IM/UG
Rev No. : 02
Page No.
:
100
of 1
50
8.3 MENUS
8.3.1 Default Display
After the Power ON or when the H/W. RESET + LED RESET keys are pressed, the relay
will display the following message.
Ashida Digital
OC/EF Relay
This window will flash momentarily showing the following.
Relay Type: Ashida Digital O/C EF Relay
Then the control will automatically move to next option.
ADR241A V01.05
Unit ID = 0001
This window shows Software version and the Unit ID
R=0000 Y=0000
B= 0000 N=0000 A
This window shows actual Primary load current as per the CT
Primary selection.
8.3.2 Main Menu Details
R=0000 Y=0000
B= 0000 N=0000 A
Default window, shows actual Primary load current as per the
CT Primary selection.
Press the Left arrow key ( ) to move to the Main Menu
Measurement
This menu is to view the current as per CT Primary and
Secondary selection.
Press the Plus / Up arrow key (+ /) to move to the next option.
Relay Setting
Password protected window for “Relay Setting’’ setting i.e.
New Password, Unit ID, IP>, IP>TMS, IP>>, IE>, IE>TMS,
IE>>, IP> Curve, IE>Curve, IP> C6 Time, IE> C6 Time, IP>>
Delay, IE>> Delay, BF Delay, CT Sec, CT Pri, Test Block, Trip
Ckt., Ann Type, Ann Cont, Trip Cont, BF Cont, Com Port, Set
Parity and Baud Rate
Press the Plus / Up arrow key (+ /) to move to the next option.