Setting Up
The ENC1201’s address
ENC 1201 Version 1.0 Page 12
3.3.1 DanteController
Another way to check the IP addresses of the remaining devices on the Dante network is
by using the “Device Info” item of the DanteController software. Dante Controller is free
software that can be downloaded from Audinate’s website (www.audinate.com). Dante
Controller detects and displays all Dante devices connected to the network and allows
you to both view information about them and to edit a number of settings.
Note:
• After logging in, you can open the web interface of other connected ENCHORUS-series’ devices
by clicking an entry in the “NAME” column on the ENC 1201’s “Browse Network” tab (see p.45).
WhatiftheENC1201’sIPAddressisnotdisplayed?
If Dante Controller fails to display the IP address of a connected ENC-series device, pro-
ceed as follows:
1. Leave Dante Controller running.
2. Disconnect the ENC 1201 from the wall outlets (to switch it o).
3. Reconnect the ENC 1201 to a wall outlet.
4. Click Dante Controller’s [Device Info] tab and wait ±15 seconds.
The ENC 1201’s IP address is displayed in Dante Controller’s list.
5. Assign a static IP address of the ENC 1201’s subnet to the connected computer.
The ENC 1201 is once again reachable.
To Next Page
Loading...
Need help?
General