ASL INTERCOM V2000 - ASL Transfer Tool for IP Configuration

V2000 User’s Manual
U-0623-0383.docx – Issue: 05 complete, approved – 17/12/15
Page 13 of 36
5.2 ASL Transfer Tool – V2000 IP Configuration
The V2000’s IP settings are configured using the ASL Transfer Tool. The tool is launched from within the
System Configuration Tool or as standalone.
1. Select the ‘Device IP’ tab - see Figure 1
a) Set the PC IP address at the top.
b) Enter the current IP and port address of
the V2000. The default is 192.168.1.101:
15356.
NOTE: If the current IP address of a
V2000 is unknown, refer to the
troubleshooting guide near the end of this
document.
c) Enter the desired new IP address.
d) Click ‘Change Device IP’.
e) The operation is successful when “IP
update: Setting IP address to ###” is
displayed - see Figure 2.
2. Reboot the V2000.
3. The new IP address will now be set.
4. Repeat the IP configuration process using the
ASL Transfer Tool for each of the remaining
V2000s.
5. Once the IP address of all V2000s have been
set correctly:
a) Ensure all units are connected to the
network.
b) Switch all MAINS switches on.
Ensure only the particular V2000 under
configuration is Ethernet connected and
powered up.
!
!
Figure
1
ASL Transfer tool – Device IP
Figure
2
ASL Transfer tool – Device IP Complete