ASL INTERCOM VIPEDIA-12 User Manual

VIPEDIA-12 Products – Installation Guide
U-0641-0344.docx – Issue: 8 complete, approved
Page 18 of 52
③
DIAG.: USB Port (only if Network Card is fitted)
Standard USB Micro-AB socket
Pin No. Signal Description
1 VBUS + V Supply (output)
2
D− Data−
3 D+ Data+
4 ID
Permits distinction of host connection from slave connection:
• Host: connected to Signal ground
• Slave: not connected
5 GND Signal ground
④
ETH3 and ETH4: 100BASE-T Ethernet Ports (if Network Card is fitted)
ETH3
1
2
3
4
5
6
7
8
ETH4
1
2
3
4
5
6
7
8
ETH3 and ETH4: Standard RJ45 socket
Pin CAT5 Cable (T568B) Signal Description
1 white/orange TRANSMIT+ 100BASE-T Ethernet
Transmitted Data
2
orange TRANSMIT- Same as above
3
white/green RECEIVE+ 100BASE-T Ethernet
Received Data
4
blue – Not used
5
white/blue – Not used
6
green RECEIVE- Same as above
7
white/brown – Not used
8 brown – Not used
⑤
ETH5 and ETH6: Optional Ethernet Ports (1 GigE)
ETH5 and ETH6: SFP Cage (can be fitted with optional SFP modules)
• MM (multimode) module (LC duplex) (Cabling: per SFP module specification)
• SM (single mode) module (LC duplex) (Cabling: per SFP module specification)
• RJ45 (copper) module (Cabling: CAT5 FTP or STP standard cable)
⑥
DBB IN 1 and OUT 1
1
: Expansion Ports
DBB IN 1
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
DBB OUT 1
These ports are used for connection of Expansion VIPEDIA-12 units
2
.
All signals are only relevant to the VIPEDIA-12 units.
Standard CAT5 FTP or STP cable must be used (maximum cable run = 4 m, entirely within the rack).
1
VIPEDIA-12 Build Standard up to 2B: EXPAND IN 1 and OUT 1
2
VIPEDIA-12 fitted with Dante Brooklyn II module does not support expansion units.

ASL INTERCOM VIPEDIA-12 Specifications

General

Brand	ASL INTERCOM
Model	VIPEDIA-12
Category	Stereo System
Language	English