3. Timer Mode
D. Confi guration
For MELR applications using the optional “S” latch bolt monitor switch
(“S” MELR), pin 5 of 8-pin ElectroLynx connector will be either NO or NC
contact depending on position of the DIP switches on motor controller
faceplate.
DIP Switch Setting for “S” Latch Bolt Monitoring
NO (Default) Shown
Door Surface
NC Alternative DIP Switch Setting
6000 Series MELR
Exit Devices
Installation Instructions
19
80-8150-0077-000 04/24
Copyright © 2017, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-577-5078 Ext. 2 • www.accentra-assaabloy.com
To Next Page
Loading...
