23
Delayed Egress
Installation Instructions
ED4000, ED5000 Series Exit Device
FM209 10/20
Copyright © 2006, 2010, 2018, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Problem Solution
Power is applied, but
unit will not arm (No red
LED).
• Check all connections on circuit board and wire harness.
• Check for power 24VDC at power inputs (-black) and (+red) and check
polarity.
• Check wire transfer for any bad connections or broken wires.
• Check power output at power supply.
• Must be 24VDC regulated.
Device alarms contin-
uously when power is
applied.
• Check trigger mechanism wire harness on circuit board and all other
connections.
• Check pushpad activating switch in device.
Units with Door Position
Switch (made by other
manufacturers).
• Make sure DPS is wired (electrically closed - with door closed) into wire
harness. Make sure DPS is working properly by using a meter to check
continuity when door is opened and closed.
Device allows mechan-
ical latchbolt retraction
with power applied and
LED shows armed.
• Check for correct power, 24VDC regulated.
• Check for correct amperage on power supply (must be rated equal or
greater than device, 500mA minimum).
Exit device latchbolt/rods
will not latch properly.
• Refer to standard exit device installation instructions troubleshooting
guide.
24 Troubleshooting
NOTE: If device is not working properly after troubleshooting, contact your local hardware distributor or
local Corbin Russwin representative, or contact Corbin Russwin 800-810-9473.
To Next Page
Loading...
