ASTEC AD-3100 - Main Power

AD-3100 Drawer Type Incubator Operation Manual Rev. 4
ASTEC CO., LTD.
18
13. Main Power
Main power switch is located in the back of the unit as shown in the figure below. Make sure that the AC
Power cable is plugged into the power outlet assigned individually for the incubator, then, turn on the unit.
Temperature display, CO
2
display and O
2
display blink on and off once turning on the unit. The control of
temperature, CO
2
and O
2
is started after the blinking stops.
Main Power Switch
Power Cable
Please start using the unit after you confirm that temperature and gases
concentration are stable at set point.
<The tolerance>
Temperature: ±0.1℃ from set point
CO
2
: ±0.3% from set point
O
2
: ±0.5% from set point