AD-3100 Drawer Type Incubator Operation Manual Rev. 4
ASTEC CO., LTD.
Thank you very much for purchasing ASTEC Drawer type incubator AD-3100. In order for you to use
this instrument properly and safely, please read this instruction manual thoroughly prior to use and retain
it for your future reference. The specifications and design of this instrument, as well as the contents of
this instruction manual, are subject to change for improvement without prior notice.
1. Safety Precautions
This section covers important safety issues. These cautionary instructions below are provided to prevent
any injuries or damages to you and other people that may be caused by unsafe and improper handling of
this instrument. The instructions are classified into 3 categories: DANGER, WARNING, and CAUTION,
in order to clearly show the degree of urgency and the extent of hazard and damage which may be
incurred if the said instructions are not followed. Please be sure to read them carefully, follow them
strictly and use this product as directed. The following symbols are used in this manual.
There is an imminent likelihood that failure to follow instructions
could result in death or serious personal injury.
Improper handling of this instrument could result in death or
serious personal injury.
Improper handling of this instrument could result in personal injury and/or
property damage.
This symbol represents Danger, Warning and Caution
This symbol represents prohibition statement.
This symbol represents directive statement.
Warnings
Connect the instrument to a line plug according to local or county standards and to the specifications.
Do not use the instrument for different purposes from those shown by the manufacturer. (See Chapter 1
for General Descriptions)
Do not switch on the instrument without having waited at least 20 seconds after switching off.
Do not open the instrument before reading the servicing specific conditions described in the manual.
Follow instruction contained in the manual in case of changing any parts
To move the instrument, at least two people are required. We suggest contacting the distributor or the
manufacturer directly for servicing.
To Next Page
Loading...
Need help?
General
