AD-3100 Drawer Type Incubator Operation Manual Rev. 4
ASTEC CO., LTD.
Pedestal, bench, desk or table where the instrument will be set up MUST be solid and
leveled even to prevent leakage of the water.
Power off and unplug the power cable when moving the instrument to different location.
Do not put heavy objects or bottles that contain liquid.
Do not get on the instrument.
Do not intentionally step on, bend or twist the power cable.
Do not lean against the instrument.
Do not lean against the door of the instrument, especially when it is open.
Use appropriate gloves when cleaning the instrument, especially for cleaning the chamber.
Remove the water from the water pan when moving the incubator to the different location.
When closing the inner and outer doors please hold the knob and handle in appropriate
manner to avoid pinching your hands or fingers.
In case any cuts or were are found on the power cable of the instrument, stop using the
cable and replace it with brand-new power cable.
The receiver of O
2
sensor should be kept away from condensation.
Used O
2
sensor should be properly discarded in order to avoid contamination of the natural
environment.
To Next Page
Loading...
Need help?
General
