ASTRO VG-877 - Page 303

Chapter 2 INDIVIDUAL FORMATS FOR VG CONTROL COMMANDS
289
Note 1 : this command is only for VG-881.
Note 2 : if there is no terminal (or not output) or the terminal cannot be tested
(including set as “Test OFF”), “0”(Invalid) is returned from those terminal.
Note 3
In case set as “ALL”, the below sequence of data is returned.
#1
Slot 1
Terminal 1
#2
Slot 1
Terminal 2
#3
Slot 1
Terminal 3
#4
Slot 2
Terminal 1
#5
Slot 2
Terminal 2
#6
Slot 2
Terminal 3
#7
Slot 3
Terminal 1
#8
Slot 3
Terminal 2
#9
Slot 3
Terminal 3
#10
Slot 4
Terminal 1
#11
Slot 4
Terminal 2
#12
Slot 4
Terminal 3