Chapter 2 INDIVIDUAL FORMATS FOR VG CONTROL COMMANDS
2.175 EXECON4 [24H 4CH] : Output Terminal Setting
Function : this command sets ON/OFF of each output terminal.
Sequence : Type 2
Command:
Output Terminal Information
#1
Output Terminal Information
Output Terminal Information
Fig. 0-1
* About output terminal code, refer to Fig.2-132-2 for VG-870, 871 and 880. Refer to Fig. 2-132-3 for VG-882
and VG-883. Refer to Fig. 2-132-4 for VG-884. Refer to Fig.2-132-5 for VG-876.
* If the output terminal code that does not exist in VG, it is ignored.
ACK or
STX+ESTS+Error Code+ETX
To Next Page
