AT&T Four-Line Intercom Speakerphone 955 User Manual

11
INSTALLATION
2 Install one 9V battery.
• Press in on the tabs and remove the telephone base.
• Use a small Phillips head screwdriver to remove the screw
and open the battery door.
• Insert the 9V battery (included), and replace the screw to
close the battery door.
• Replace the telephone base.
NOTE: The battery retains telephone memory in the event of a power
failure. If power fails and a working battery is installed, this phone will
work only to dial and answer calls with the handset or headset. No other
features will work until power is restored.
3 Connect the telephone line cords to the telephone.
Please refer to line cord connection instructions in Step 2 of
“Table/Desk Installation” on page 9.
4 Turn the base, as shown, and attach it to the bottom of
the phone.
955_00_1ATT CIB #change 10/24/02 9:48 AM Page 11

AT&T Four-Line Intercom Speakerphone 955 Specifications

General

Brand	AT&T
Model	Four-Line Intercom Speakerphone 955
Category	Telephone
Language	English