TELEPHONE OPERATION
24
To answer a call, press h. Press h again to end the call.
To switch from handset to headset or speakerphone, press h or
K, then replace the handset (for headset, headset must be plugged in).
To switch from speakerphone to handset, lift the handset. (Do not
press K or the call will be disconnected.)
To switch from headset to speakerphone (when handset is in the
cradle), press K.
To switch from headset to speakerphone (when handset is off-hook),
press K and replace the handset.
To switch from speakerphone to headset, insert the headset plug into
the jack, and press h.
To override automatic line selection, press and release a LINE button
(this activates the speakerphone or headset).
Timer
When you make or answer a call, the timer automatically starts. The screen
displays the elapsed time in minutes and seconds for the first hour (up to
59:59 ) and then begins again. The timer stops automatically when you
hang up and the recorded time is displayed for about 10 seconds.
The timer also stops when you place a call on hold and resets when you
release hold.
Call Privacy
To ensure call privacy, the phone allows only one set at a time to use a line.
Canceling Call Privacy
During the call, press the LINE button for the call. You’ll hear a short beep.
Others can now join the call.
Restoring Call Privacy
Press the LINE button again during the call. You’ll hear a double-beep. The
other phones will be dropped from the call.
NOTE: Call privacy is automatically restored when you end the call.
NOTE: When a non-system phone answers a call, any other system phone
can pick up the call by pressing the LINE button. Once a system phone
picks up the call, Call Privacy is activated and no other system phones can
listen to the call unless Call Privacy is canceled, but non-system phones
which share that line can still join the call.
To Next Page
Loading...
Need help?
General
