Trouble on One Voice Terminal
Step 10.
On both voice terminals, perform the action that revealed the trouble.
IF
THEN
Some or all of the terminal exten-
Trouble found.
It is caused by
sion cords have been switched and
the
terminal extension cord
just
the trouble appears on the voice
connected to the voice terminal
terminal that at first had no trou-
that at first had no trouble.
ble,
Replace the terminal extension
cords as they were and obtain a
replacement for the defective cord.
Read the section on Maintenance
Exchange Procedures at the end of
this manual.
All terminal extension cords have
The switched terminal extension
been switched and the trouble
cords are not causing the problem.
appears on the voice terminal that
Replace the cords as they were.
at first had the trouble,
Go on to Step 11.
Some terminal extension cords
Replace the terminal extension
have not been switched and the
cords as they were. Go back to
trouble appears on the voice termi-
Step 9 to switch another terminal
nal that at first had the trouble,
extension cord.
Step 11.
Determine whether there are other components between the control unit
and the voice terminal that have trouble.
IF
Jack panels are the only other
components used,
Jack panels, cables, and/or 103A
Modular Jacks are used,
No other components are used,
THEN
Trouble found.
It is caused by
the
modular to modular connector
in the jack panel that is connected
to the voice terminal with trouble.
Read the section on Maintenance
Exchange Procedures at the end of
this manual.
Go on to Step 12.
Call your equipment supplier for
help.
Page 45
To Next Page
Loading...
Need help?
General
