AT&T SB3014 User Manual

37
Registering wireless mics
Your wireless mics are pre-registered. If for some reasons, you want to
purchase replacement wireless mics (AT&T model SB3014-WM), visit our
website at www.smbtelephones.att.com or call 1 (800) 222-3111.
In Canada, dial 1 (866) 288-4268. Each new wireless mic must be
registered to the base unit before use.
Follow the instructions on this page to register your new wireless mics to the
base unit.
Register a wireless mic to your base unit
As part of this registration process, all existing, broken, or misplaced wireless
mics will be deregistered first. Then, the base unit will re-register the four
wireless mics that are placed on the charging cradles.
Before registration, unplug the telephone line cord from the wall jack to
make sure there are no incoming calls during the registration.
1. Gather the four wireless mics that are to be registered and place them on
the charging cradles. Registration has not yet started.
2. Enter 331734 on the base unit when it is not in use, then press .
The screen displays Please place all wireless mics on cradle, then
press ‘SELECT’.
3. Make sure all the four wireless mics are on the charging cradles, and then
press . The wireless mics enter the deregistration mode, and the
screen displays Processing...
Registration starts after deregistration completed. The screen displays
Registering... 1 2 3 4. The number X blinks while registering the X-th
wireless mic. The status indicators on the wireless mics flash red and
green, alternately. You hear a confirmation tone when each wireless mic
is registered. When all the four wireless mic are registered, the base unit
displays Registration done.
After registration, plug the telephone line cord back into the wall jack.
NOTES:
If registration failed, there is an error tone and the base unit displays Registration failed.
Try again, and returns to idle mode. Remove the wireless mics from the charging cradles and
start again from Step 1.
If the screen does not display Registration done after Registering... 1 2 3 4, start again from
Step 1.
All wireless mics should be kept on the charging cradles during deregistration and
registration. Any wireless mic, that is registered before but is not put on the charging cradle,
will be deregistered.
To cancel registration, press . The base unit displays Registration cancelled. If
registration is cancelled, some of the wireless mics may be deregistered. To register them back
to the base unit, start again from Step 1.
•
•
•
•
Appendix

AT&T SB3014 Specifications

General

Brand	AT&T
Model	SB3014
Category	Telephone
Language	English