EasyManuals Logo

AT&T SB67108 - AT&T User Manual

AT&T SB67108 - AT&T
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Getting started
Add and register a cordless headset
You can use this phone handsfree when you register a DECT
6.0 cordless headset (AT&T model TL7600, sold separately)
to the telephone base. You can only register one cordless
headset to the telephone base. The cordless headset must
have a charged battery. Make sure the headset battery is
properly installed.
Place the headset in the headset charger and note the color
of the ON/OFF button. If the button flashes a blue and
orange light twice every five seconds, the headset is unregistered. If the
button shows a constant blue light, the headset is registered. You need to
deregister the headset before you can register it to the SynJ SB67138. See
the deregistration instructions in the user’s manual of the telephone to which
it is currently registered. See page 81 for instructions on using the cordless
headset with this telephone.
12
Place the headset in the headset charger and allow
it to charge for at least five minutes before beginning
registration. Make sure the headset is out of the headset
charger before you begin registration.
On the telephone base, press MENU
/ENTER.
Scroll down to Registration and press MENU/ENTER.
Press MENU/ENTER again to select Register HS. The
telephone base shows Registering new device... It takes
up to 60 seconds to complete the registration.
Place the headset into the cradle. The telephone base
shows Cordless headset registered and beeps when the
registration is successful.
Lift the headset, then press the headset ON/OFF button. If
you hear a dial tone and the extension
0
icon appears on
the telephone base, the registration was successful.
If there is no dial tone, or the ON/OFF light on the headset
flashes twice every five seconds, the registration was not
successful. Remove the headset from the headset charger
and repeat the registration process again, starting with Step
2 above.
If you have a dial tone but an extension number other than
0 displays on the telephone base, the headset is registered
as a handset and will not function properly. If this is the
case, you must deregister and start over. See Deregister
devices on the next page.
1.
2.
3.
4.
5.
6.
COVM
Speed dial setup
Customer support
Registration
>
Register HS
Deregistration
>
Cordless headset
registered
Registering
new device...
Line1 00:00:05
0
To register a cordless headset to your telephone base

Table of Contents

Other manuals for AT&T SB67108 - AT&T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T SB67108 - AT&T and is the answer not in the manual?

AT&T SB67108 - AT&T Specifications

General IconGeneral
BrandAT&T
ModelSB67108 - AT&T
CategoryTelephone
LanguageEnglish

Related product manuals