11 Rev. 00
Qualifica 3
The person with this qualification has a specific education in electronically controlled Automatic
Machines and he/she is qualified for electric works. This qualification enables the person to
perform installation, regulation, routine or remedial maintenance works. The person will reach
this qualification by means of thorough reading of these instructions and training by ATLA COOP
Service.
1.3 Handbook's Layout
This handbook has been drafted and drawn up in compliance with the Machinery Directive (98/
37)CE and the technical and safety standards there quoted when applicable. The handbook's layout
is as follows:
— Page for the indentification of the rating (relating to the specific machine).
— List of the valid pages.
— List of the revised pages.
— Table of contents.
— Enclosed documents.
The enclosed documents enable the purchaser to personalize the machine to his/her needs. The list
of the valid pages contains the indication of quantity of pages of each section in order to check the
handbook's completeness.
1.4 How to keep this Handbook
This handbook must always be available to the user in order to enable him/her to operate correctly
the machine. Therefore, this handbook must be kept near the machine in a dry place provided for
the purpose, far from heat sources and any other climatic condition that may damage it. To achieve
a precise knowledge of the machine it is necessary that the handbook is complete. Check therefore
its completeness with reference to the list of contents. In case of its lost or damage, please, contact
the company ATLA COOP for a further copy.
To Next Page
Loading...
Need help?
General