40 Rev. 00
7.3 Troubleshooting
The machine is not fitted with a software/devices fault locating system. Therefore, the user/operator
must check the correct machine functioning by controlling the good quality of crimping cycle.
The machine GAMMA is designed and constructed using components and materials with controlled
technical features, for this reason the failures and malfunctioning are not frequently. In case of failures
not foreseen during the machine functioning, please, contact the company ATLA COOP.
7.4 Remedial maintenance
The remedial maintenance( or not programmed maintenance) permits to replace most of the machine
components. See the tables enclosed in this handbook for the complete list of spare parts. In case of
difficulty in replacing spare parts or in case they may not be available, please, contact ATLA COOP
Assistance Service.
! ! WARNING
! !
The use of not original or not specific spare parts may
cause risks and hazards not due to the machine, as they
change its foreseen layout. The company ATLA COOP
shall not be liable for incidental or consequential damages
resulting from it.
7.5 Technical assistance
The crimping machine GAMMA service is directly carried out by ATLA COOP. Contact ATLA
COOP Service dialling the following numbers:
tel. : 055 / 8498428
fax. : 055 / 8498430
To Next Page
Loading...
Need help?
General