36 Rev. 00
7 MAINTENANCE
7.1 General
This section describes the routine and remedial maintenance operations to be carried out on the
machine and contains useful information about possible working defects you might encounter while
operating the machine. Routine maintenance operations are planned interventions to be regularly
carried out, whereas remedial maintenance operations are interventions to be carried out in order to
restore the correct machine working after ruptures, failures and/or malfunctionning.
7.2 Routine maintenance
To maintain perfect performance and efficiency of the machine you must carry out the maintenance
operations planned by the manufacturer according to the machine operating time. The observance
of the programme below reduced the possibility of defects, malfunctionning or failures. The table
below is a list of maintenance operations to be regularly carried out with the indication of the operation
frequency and the description of the procedure.
! ! ! WARNING ! ! !
Before carring out any maintenance operations (unless
otherwise stated), disconnect the machine from the
pneumatic supply (disconnecting the air pipe from the
quick coupling).
Daily Outside and inside cleaning of the machine
Monthly Condensate drainage from the air regulator
Six-monthly Control the oil level in the air regulator and if necessery fill up (oil for
pneumatic circuits)
Six-monthly Lubrification of the machine
FREQUENCY OPERATION
To Next Page
Loading...
Need help?
General