3 Rev. 00
5 OPERATING INSTRUCTIONS
5.1 Operating Commands and Control Devices 5-1
5.2 Other Commands on the Crimping Machine 5-2
5.3 How to start and stop the Machine 5-2
5.3.1 Start 5-2
5.3.2 Stop 5-2
5.4 Machining cycle 5-3
5.5 How to work a profile 5-4
5.5.1 How to adjust the Vertical Cylinder 5-4
5.5.2 How to adjust the Eccentric Guides 5-5
5.5.3 How to mount and adjust the Bracing Clamp 5-6
5.5.4 How to mount and adjust the Crimping Tools 5-7
5.5.5 How to adjust the Reference Forks 5-9
6 GUIDELINES FOR SAFE USE
6.1 General 6-1
6.2 Safety Devices 6-1
6.3 Protective Devices 6-2
6.4 Personal Protection Equipment 6-2
6.5 Residual Risks 6-2
7 MAINTENANCE
7.1 General 7-1
7.2 Routine Maintenance 7-1
7.2.1 How to clean the machine 7-2
7.2.2 How to drain condensate from the air regulator 7-2
7.2.3 Control of the oil level in the air regulator and filling up 7-3
7.2.4 How to lubricate the Machine 7-4
7.3 Troubleshooting 7-5
7.4 Remedial Maintenance 7-5
To Next Page
Loading...
Need help?
General