Outdoor/altitude operation
The compressor is not designed for installation outdoors.
The compressors can be sold with option rain protection. With this option, this compressor
can be installed outside under a shelter, in frost free conditions. If frost might occur, the
appropriate measures must be taken to avoid damage to the machine and its ancillary
equipment. Consult Atlas Copco.
Moving/lifting
The compressor can be moved by a lift truck using the slots in the frame. Take care not to
damage the bodywork during lifting or transport. Make sure that the forks protrude from the
other side of the frame. The compressor can also be lifted after inserting beams in the
slots. Make sure that the beams cannot slide and that they protrude from the frame equally.
The chains must be held parallel to the bodywork by chain spreaders in order not to
damage the compressor. The lifting equipment must be placed in such a way that the
compressor is lifted perpendicularly. Lift gently and avoid twisting.
In case of units equipped with the Lifting Device Option, it is not allowed to lift the
compressor if the canopy parts or lifting supports are not completely installed. When the
compressor is being lifted, it is also forbidden to come under the load or to perform
maintenance activities to it.
Instruction book
132 2920 7180 30
To Next Page
Loading...
