FMB10 User’s Manual Edition 06/2005
___________________________________________ Page 41 _____________________________________________
Audemat-Aztec SA – Audemat-Aztec INC
WEB: www.audemat-aztec.com - e-mail: contact@audemat-aztec.com
ASCII instruction syntax
ASCII instruction description
FMB10 Encoder
Example(s) and comments
KEY=v
v from 0 to 250
System command.
This system command is to be used to enter
the secret code to unlock the write protection
on the parameters stored in the FMB10
encoder’s permanent memory
If the code entered corresponds to the RDS
encoder’s secret code, it sends a "+" and
opens access to the commands allowing the
parameters to be modified.
The unlocking remains active during 60
seconds after the last valid command entered
into the FMB10 encoder.
▲ WARNING
3 failed attempts will make the
encoder "deaf" to any new command during 18
hours of operation. After this time, you will be
given another three attempts.
The "KEY?" command displays the number of
attempts you have left.
▲ IMPORTANT: If you have lost the secret
code of the RDS encoder, contact your
distributor who will give you a password to
unlock it.
See also
: NKEY=
LEVEL=v
v from 0 to 3199
This system command defines the RDS signal
output level in "mVcc" from 1 to 3199mVcc.
"LEVEL=0" deactivates the LEVEL command
and activates the command "ATT=".
See also
: ATT=
ASCII Mode : the LEVEL
parameter may be reread with
the command LEVEL?
MS=0
or
MS=1
MS : Music/Speech switch
MS=1 music mode
MS=0 speech mode
Rarely used by RDS radio receivers, it is
nevertheless preferable to configure this "MS"
parameter according to the format of the radio
station.
ASCII Mode : the MS parameter
may be reread with the command
MS?
To Next Page
Loading...