Audi A4 2015 - Overview - Coolant Valves; Electric Coolant Pump, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4 Overview - Coolant Valves
1 - Transmission Coolant
Valve - N488-
❑ Equipped on some
models
❑ Removing and Instal‐
ling. Refer to
⇒ “2.11.1 Transmission
Coolant Valve N488 ,
Removing and Instal‐
ling”, page 109 .
2 - Coolant Hose
3 - Bolt
❑ 23 Nm
4 - Bracket
❑ For the Transmission
Coolant Valve - N488-
5 - Nut
❑ 9 Nm
6 - Coolant Hose
2.5 Electric Coolant Pump, Removing and
Installing
⇒ “2.5.1 Coolant Recirculation Pump V50 , Removing and In‐
stalling”, page 103
⇒ “2.5.2 After-Run Coolant Pump V51 , Removing and Installing”,
page 104
2.5.1 Coolant Recirculation Pump - V50- , Re‐
moving and Installing
Special tools and workshop equipment required
♦ Hose Clamps - Up To 25 mm - 3094-
♦ Hose Clip Pliers - VAS6340-
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Coolant Pump/Coolant Thermostat 103