Audi A4 2015 - 1.2 Engine, Securing to Engine and Transmission Holder

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Engine, Securing to Engine and Trans‐
mission Holder
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 10 ; Engine, Removing and Installing; Engine, Securing
to Engine and Transmission Holder .
1.3 Engine, Installing
Special tools and workshop equipment required
♦ All special tools listed within Engine, Removing. Refer to
⇒ “1.1 Engine, Removing”, page 4 .
Procedure
• Replace the bolts that were tightened with an additional turn
after removing them.
• Replace the self-locking nuts and bolts, gaskets, seals and O-
rings after removing.
• A needle bearing must be installed in the drive plate on vehi‐
cles with a manual transmission. Refer to ⇒ Servicing – 4-
Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 13 ; Cylinder
Block, Transmission Side; Needle Bearing in Drive Plate, Re‐
placing .
• Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
• During installation, all cable ties must be installed at the same
location.
• Used coolant cannot be used again.
– Install the engine on the transmission but do not tighten the
bolts that connect the transmission to the engine yet. Refer to
⇒ Manual Transmission; Rep. Gr. 34 ; Transmission, Re‐
moving and Installing; Transmission, Installing .
TIP:
The bolt -2- attaches the starter to the transmission and has an
additional spacer sleeve -arrow-.
• The spacer sleeve must be inserted between the starter and
the transmission.
– Install the starter. Refer to ⇒ Electrical Equipment; Rep. Gr.
27 ; Starter; Starter, Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Engine, Removing and Installing 31