Audi A4 2015 - Subframe Mount; Overview - Subframe Mount

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Subframe Mount
⇒ “2.1 Overview - Subframe Mount”, page 35
⇒ “2.2 Engine, Supporting in Installation Position”, page 38
⇒ “2.3 Engine Mount, Removing and Installing”, page 38
⇒ “2.4 Transmission Mount, Removing and Installing”,
page 41
2.1 Overview - Subframe Mount
♦ Overview - Engine Mount. Refer to ⇒ page 35 .
♦ Overview - Manual Transmission Mount. Refer to
⇒ page 36 .
♦ Overview - Dual Clutch Transmission Mount. Refer to
⇒ page 37 .
Overview - Engine Mount
1 - Subframe
2 - Bolt
❑ 20 Nm
3 - Bolt
❑ 10 Nm
4 - Support Bearing
❑ Installation position. Re‐
fer to
⇒ Fig. ““Support Bear‐
ing, Installation Posi‐
tion”“ , page 36 .
❑ Removing and instal‐
ling. Refer to
⇒ “2.3.2 Support Bear‐
ing, Removing and In‐
stalling”, page 40 .
5 - Bolt
❑ 55 Nm
6 - Engine Support
❑ Removing and instal‐
ling. Refer to
⇒ “1.6 Engine Support,
Removing and Instal‐
ling”, page 49 .
7 - Heat Shield
8 - Bolt
❑ 10 Nm
9 - Bolt
❑ 55 Nm
10 - Engine Mount
❑ With
♦ Left Electrohydraulic Engine Mount Solenoid Valve - N144-
♦ Right Electrohydraulic Engine Mount Solenoid Valve - N145-
❑ Removing and installing. Refer to ⇒ “2.3.1 Engine Mount, Removing and Installing”, page 38 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Subframe Mount 35