Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
CAUTION
There Is a Risk of Destroying the Control Modules Due to Ex‐
cessive Voltage
– Do not use a battery charger to jump start!
After Replacing the Engine, Adaptations Need to be Made. Refer
to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr.
00 ; Repair Information ; Perform Adaptations after Replacing
Components.
– Connect the coolant hose to the connector coupling. Refer to
⇒ Fig. ““Connect the Coolant Hose to the Connector Cou‐
pling”“ , page 119 .
– Fill with coolant. Refer to
⇒ Fig. ““Coolant, Filling”“ , page 97 .
– Install the wheel housing liners and wheel spoilers. Refer to ⇒
Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner; Overview
- Front Wheel Housing Liner .
– Install the front wheels. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 44 ; Wheels, Tires .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Noise Insulation; Overview - Noise Insulation .
Tightening Specifications
♦ The tightening specifications only apply to lightly greased,
oiled, phosphated or blackened nuts and bolts.
♦ Additional lubricants, such as engine or transmission oil are
permissible, although lubricants containing graphite are not.
♦ Do not use any ungreased parts.
♦ Tightening specification tolerance: ±15%.
Component Tightening
Specifications
Bolts and nuts M6 9 Nm
M7 15 Nm
M8 20 Nm
M10 40 Nm
M12 65 Nm
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
♦ Engine to transmission. Refer to ⇒ Transmission; Rep. Gr.
34 ; Transmission, Removing and Installing; Transmission
Tightening Specifications .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
34 Rep. Gr.10 - Engine Assembly
To Next Page
Loading...
