Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.3 Sliding Bar Ball, Installing
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 15 ; Valvetrain ; Sliding Bar Ball, Installing.
4.4 Cam Adjustment Actuator, Removing
and Installing
Refer to ⇒ Servicing – 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.
15 ; Valvetrain ;
4.5 Camshaft Adjustment Valve 1 - N205- ,
Removing and Installing
The procedure description applies to the Camshaft Adjustment
Valve 1 - N205- and the Exhaust Camshaft Adjustment Valve 1 -
N318- .
Removing
Exhaust Camshaft Adjustment Valve 1 - N318- :
– Remove the lock carrier cover. Refer to ⇒ Body Exterior; Rep.
Gr. 63 ; Front Bumper .
– Remove the bolts -arrows- and the air guide -2-.
Refer to ⇒ Rep. Gr. 15 ; Valvetrain; Cam Adjustment Valve 1 -
N205- / Exhaust Cam Adjustment Valve 1 - N318- , Removing
and Installing .
Installing
Additional procedures:
– Install the lock carrier cover. Refer to ⇒ Body Exterior; Rep.
Gr. 63 ; Front Bumper .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Air Filter Housing”, page 149
4.6 Valve Stem Seals, Removing and In‐
stalling
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 15 ; Valvetrain; Valve Stem Seals, Removing and In‐
stalling .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4. Valvetrain 75
To Next Page
Loading...
