Audi A4 2015 - 4 Radiator;Radiator Fan

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Radiator/Radiator Fan
⇒ “4.1 Overview - Radiator/Radiator Fan”, page 118
⇒ “4.2 Radiator, Removing and Installing”, page 120
⇒ “4.3 Fan Shroud, Removing and Installing”, page 124
⇒ “4.4 Radiator Fan V7 , Removing and Installing”, page 125
4.1 Overview - Radiator/Radiator Fan
♦ Overview - Radiator. Refer to ⇒ page 118 .
♦ Overview - Fan Shroud and Radiator Fan. Refer to
⇒ page 119 .
Overview - Radiator
1 - Radiator
❑ After replacing, replace
entire amount of coolant
❑ Removing and instal‐
ling. Refer to
⇒ “4.2 Radiator, Remov‐
ing and Installing”, page
120 .
❑ If there are small im‐
pressions on the slats.
Refer to ⇒ Rep. Gr. 00 ;
Repair Information; Ra‐
diator and Condenser
Assembly .
2 - Plug
❑ Do not open
❑ Not available separate‐
ly.
3 - O-Ring
❑ Not available separate‐
ly.
4 - Coolant Hose
❑ Lift the clamp to remove
❑ Connecting. Refer to
⇒ Fig. ““Connect the
Coolant Hose to the
Connector Coupling”“ ,
page 119 .
5 - O-Rings
❑ Not available separate‐
ly; replace if leaking
-item 4-
⇒ Item 4 (page 118) or
-item 6-
⇒ Item 6 (page 118)
damaged
6 - Coolant Hose
❑ Lift the clamp to remove
❑ Connecting. Refer to ⇒ Fig. ““Connect the Coolant Hose to the Connector Coupling”“ , page 119 .
7 - Coolant Ventilation Line
❑ To the coolant expansion tank
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
118 Rep. Gr.19 - Cooling System