Audi A4 2015 - Radiator, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Fan Shroud
❑ Removing and instal‐
ling. Refer to
⇒ “4.3 Fan Shroud, Re‐
moving and Installing”,
page 124 .
2 - Bolt
❑ 5 Nm
3 - Radiator Fan - V7-
❑ With Radiator Fan Con‐
trol Module - J293-
❑ Removing and instal‐
ling. Refer to
⇒ “4.4 Radiator Fan V7 ,
Removing and Instal‐
ling”, page 125 .
4 - Back Pressure Door
❑ Equipped on some
models
❑ There are different ver‐
sions. Refer to the Parts
Catalog.
4.2 Radiator, Removing and Installing
Special tools and workshop equipment required
♦ Coolant Collection System - VAS5014- or Shop Crane - Drip
Tray - VAS6208-
♦ Elbow Assembly Tool - T10118-
The radiator is removed and installed together with the fan
shroud.
Removing
– Remove the front noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Noise Insulation, Removing
and Installing .
– Remove the bumper cover bracket together with the impact
member. Refer to ⇒ Body Exterior; Rep. Gr. 50 ; Lock Carrier;
Overview - Lock Carrier .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
120 Rep. Gr.19 - Cooling System