Audi A4 2015 - Engine Temperature Control Actuator N493, Removing and Installing; Engine Coolant Temperature Sensor G62, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.8 Engine Temperature Control Actuator -
N493- , Removing and Installing
Removing
– Drain the coolant. Refer to
⇒ “1.3 Coolant, Draining and Filling”, page 96 .
– Lift the clamps -arrows-, remove and free up the coolant ho‐
ses.
– Disconnect the connector -1- for the Engine Coolant Level
Sensor - G32- .
– Remove the bolt -2- and remove the coolant expansion tank
-3-.
All additional procedures are described. Refer to ⇒ Servicing –
4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 19 ; Coolant
Pump/Coolant Regulation ; Engine Temperature Control Actuator
- N493- , Removing and Installing.
Installing
Additional procedures:
– Connect the coolant hose to the connector coupling. Refer to
⇒ Fig. ““Connect the Coolant Hose to the Connector Cou‐
pling”“ , page 119 .
2.9 Engine Coolant Temperature Sensor -
G62- , Removing and Installing
⇒ “2.9.1 Engine Coolant Temperature Sensor G62 , Removing
and Installing, Vehicles without Particulate Filter”, page 107
⇒ “2.9.2 Engine Coolant Temperature Sensor G62 , Removing
and Installing, Vehicles with Particulate Filter”, page 107
2.9.1 Engine Coolant Temperature Sensor -
G62- , Removing and Installing, Vehi‐
cles without Particulate Filter
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 19 ; Coolant Pump/Coolant Regulation; Engine Coolant
Temperature Sensor - G62- , Removing and Installing .
2.9.2 Engine Coolant Temperature Sensor -
G62- , Removing and Installing, Vehi‐
cles with Particulate Filter
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
2. Coolant Pump/Coolant Thermostat 107