Audi A4 2015 - Page 125

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Lift the clamp to remove
❑ Connecting. Refer to ⇒ Fig. ““Connect the Coolant Hose to the Connector Coupling”“ , page 119 .
8 - O-Ring
❑ Not available separately; replace if leaking -item 7- ⇒ Item 7 (page 118) or damaged
9 - Rubber Bushing
❑ For the radiator
10 - Sleeve
11 - Retaining Pin
❑ Disengage and remove using the screwdriver
12 - Air Duct
13 - Rubber Bushing
❑ For the radiator
14 - Radiator Bracket
15 - Bolt
❑ 5 Nm
16 - Backing Plate
17 - Bolt
❑ 4.5 Nm
Connect the Coolant Hose to the Connector Coupling
– Replacing the damaged clip -4-.
– Check the O-ring -2- for damage. The O-ring is not available
individually, if necessary, replace the concerning component.
– Coat the O-ring with coolant on the new component.
– Press the coolant hose onto the connection -1- until it engages
audibly.
– Press the coolant hose on again and pull to make sure the
connector coupling is engaged correctly.
Overview - Fan Shroud and Radiator Fan
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4. Radiator/Radiator Fan 119