Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3 Cylinder Head
⇒ “3.1 Overview - Cylinder Head”, page 62
⇒ “3.2 Cylinder Head, Removing and Installing”, page 62
⇒ “3.3 Compression, Checking”, page 68
3.1 Overview - Cylinder Head
Refer to⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep.
Gr. 15 ; Cylinder Head; Overview - Cylinder Head .
Heat Shield - Tightening Specification
– Tighten the nuts -arrows- and bolt -2- to 9 Nm.
Heat Shield Bracket - Tightening Specification
– Tighten the bolt -1- to 9 Nm.
3.2 Cylinder Head, Removing and Installing
⇒ “3.2.1 Cylinder Head, Removing and Installing, Vehicles with‐
out Particulate Filter”, page 62
⇒ “3.2.2 Cylinder Head, Removing and Installing, Vehicles with
Particulate Filter”, page 65
3.2.1 Cylinder Head, Removing and Installing,
Vehicles without Particulate Filter
Removing
– Remove the camshafts. Refer to
⇒ “4.2 Camshaft, Removing and Installing”, page 69 .
CAUTION
Risk of Destroying the Engine by Adjusting the Valve Timing
– Do not turn the crankshaft after removing the camshafts.
– Remove the Throttle Valve Control Module - GX3- . Refer to
⇒ “3.3 Throttle Valve Control Module GX3 , Removing and
Installing”, page 158 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
62 Rep. Gr.15 - Cylinder Head, Valvetrain
To Next Page
Loading...
