Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the front muffler bolts -arrows-.
– Loosen the threaded connections -arrows- and slide the
clamping sleeves toward the rear.
CAUTION
Risk of Damaging the Coupling Due to Improper Handling
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Slightly lower the front muffler -2- and secure as shown with a
cable tie -1-.
– Drain the coolant. Refer to
⇒ “1.3 Coolant, Draining and Filling”, page 96 .
– Remove the nut -arrow- and move the bracket -1- and wiring
harness to the side.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
3. Cylinder Head 63
To Next Page
Loading...
