Audi A4 2015 - 4 Valvetrain

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Valvetrain
⇒ “4.1 Overview - Valvetrain”, page 69
⇒ “4.2 Camshaft, Removing and Installing”, page 69
⇒ “4.3 Sliding Bar Ball, Installing”, page 75
⇒ “4.4 Cam Adjustment Actuator, Removing and Installing”, page
75
⇒ “4.5 Camshaft Adjustment Valve 1 N205 , Removing and In‐
stalling”, page 75
⇒ “4.6 Valve Stem Seals, Removing and Installing”, page 75
4.1 Overview - Valvetrain
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 15 ; Valvetrain; Overview - Valvetrain .
4.2 Camshaft, Removing and Installing
⇒ “4.2.1 Camshaft, Removing and Installing, Vehicle without Par‐
ticulate Filter”, page 69
⇒ “4.2.2 Camshaft, Removing and Installing, Vehicle with Partic‐
ulate Filter”, page 72
4.2.1 Camshaft, Removing and Installing, Ve‐
hicle without Particulate Filter
Removing
– Remove the front noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Noise Insulation, Removing
and Installing .
– Disconnect the connector -arrow- for the Oil Level Thermal
Sensor - G266- .
– Remove the air filter housing. Refer to
⇒ “2.2 Air Filter Housing, Removing and Installing”,
page 150 .
– Remove the upper timing chain cover. Refer to ⇒ Servicing –
4-Cylinder 1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 15 ; Timing
Chain Cover; Timing Chain Cover, Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4. Valvetrain 69