Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– When installing, position the clamping sleeves -arrows- on the
center of the separation cut.
– Install the clamping sleeves. Refer to
⇒ Fig. ““Rear Clamping Sleeve - Installation Position”“ ,
page 171 .
– Install the exhaust system without tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”,
page 177 .
1.3 Front Muffler, Removing and Installing
⇒ “1.3.1 Front Muffler, Removing and Installing, Vehicle without
Particulate Filter”, page 174
⇒ “1.3.2 Front Muffler, Removing and Installing, Vehicle with Par‐
ticulate Filter”, page 175
1.3.1 Front Muffler, Removing and Installing,
Vehicle without Particulate Filter
Removing
– Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
– Remove the nuts -1- from the front muffler accessible from the
top.
– Remove the rear noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Remove the nut -2- and bolt -3- for the front muffler.
– Remove the front muffler bolts -arrows-.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
174 Rep. Gr.26 - Exhaust System, Emission Controls
To Next Page
Loading...
