Audi A4 2015 - Oil Pump, Removing and Installing; Oil Pan Upper Section, Removing and Installing; Oil Level Thermal Sensor G266, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
TIP:
Risk of damaging the drive axle: when lifting the engine the drive
axles must not come into contact with the suspension struts.
– Lift the engine using the -10-222A/11- -1- to dimension -a-.
• Dimension -a- = approximately 20 mm.
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 17 ; Oil Pan/Oil Pump; Oil Pan Lower Section, Removing
and Installing .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
♦ Wiring harness bracket. Refer to ⇒ Wiring diagrams, Trouble‐
shooting & Component locations.
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner;
Overview - Front Wheel Housing Liner .
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
1.4 Oil Pump, Removing and Installing
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 17 ; Oil Pan/Oil Pump; Oil Pump, Removing and Instal‐
ling .
1.5 Oil Pan Upper Section, Removing and
Installing
Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 17 ; Oil Pan/Oil Pump; Oil Pan Upper Section, Removing
and Installing .
1.6 Oil Level Thermal Sensor - G266- , Re‐
moving and Installing
Refer to ⇒ Servicing – 4-Cylinder 2.0L 4V TFSI Engine (EA 888
Generation III); Rep. Gr. 17 ; Oil Pan/Oil Pump; Oil Level Thermal
Sensor - G266- , Removing and Installing .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Oil Pan/Oil Pump 87