Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the bolt -arrow- and free up the bracket -1- with the
wiring harness.
– Remove the left and right lower bolt -1- for the support bearing
-2-.
– Remove the left and right bolt -2- from the engine mount.
– Support the engine in the installation position. Refer to
⇒ “2.2 Engine, Supporting in Installation Position”, page 38 .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
86 Rep. Gr.17 - Lubrication
To Next Page
Loading...
