Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Loosen the clamping sleeve -arrows- and push toward the
rear.
CAUTION
Risk of Damaging the Coupling Due to Improper Handling
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Remove the front muffler.
Installing
Install in reverse order of removal and note the following:
• Replace seals and self-locking nuts after disassembly.
– Install the exhaust system without tension. Refer to
⇒ “1.5 Exhaust System, Installing without Tension”,
page 177 .
Tightening Specifications
♦ Refer to ⇒ “1.1 Overview - Muffler”, page 169
1.4 Muffler, Removing and Installing
Removing
– Equipped on some models: remove the left and right diagonal
brace. Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Underbody
Trim Panel; Overview - Underbody Bracing .
– Loosen the clamping sleeve -arrows- and push toward the
rear.
CAUTION
Risk of damaging the coupling due to improper handling.
– Coupling must not be bent more than 10°.
– Do not load the coupling on the cable.
– Slightly lower the front muffler and remove the clamping
sleeve.
– Tie up the front muffler.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
176 Rep. Gr.26 - Exhaust System, Emission Controls
To Next Page
Loading...
