Audi A4 2015 - Air Filter Housing, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Removing and Installing. Refer to ⇒ Maintenance ; Booklet 830 ; Maintenance Work; Air Filter; Filter
Element, Replacing; Housing, Cleaning
11 - Air Duct Pipe
❑ Pay attention to the marks for installing
❑ Screw-type clamp tightening specification. Refer to ⇒ Servicing – 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 21 ; Charge Air System; Overview - Charge Air Hose Connections .
12 - Bolt
❑ 1.5 Nm
❑ Thread cutting
❑ Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specifi‐
cation.
13 - Heat Shield
14 - Air Duct
❑ On the lock carrier
❑ Clean off any salt and dirt
15 - Bolt
❑ 2.5 Nm
❑ Thread cutting
❑ Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specifi‐
cation.
2.2 Air Filter Housing, Removing and Instal‐
ling
Special tools and workshop equipment required
♦ Engine Bung Set - VAS6122-
Removing
– Remove the lock carrier cover. Refer to ⇒ Body Exterior; Rep.
Gr. 63 ; Front Bumper .
– Versions with Air Filter Bypass Door Valve - N275- : discon‐
nect the connector -2-.
– Remove the water drain -1- downward in direction of -arrow-.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
150 Rep. Gr.24 - Multiport Fuel Injection