Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Individual Mounting Components for Front Muffler
1 - Spacer Sleeve
2 - Pressure Spring
3 - Washer
4 - Bolt - 23 Nm
5 - Bolt - 23 Nm
6 - Spacer Sleeve
7 - Buffer
8 - Tab
9 - Spacer Sleeve
Front Clamping Sleeve - Installation Position
– Install the clamping sleeve in the position shown.
• Angle -α- = approximately 20°.
• The threaded connections are to the right.
• Nuts downward.
Rear Clamping Sleeve - Installation Position
– Install the clamping sleeve in the position shown.
• Threaded connections are to the left.
• Nuts downward.
• Bolt ends must not protrude over the lower edge of the clamp‐
ing sleeve.
1.1.2 Overview - Muffler, AWD Vehicles
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Exhaust Pipes/Mufflers 171
To Next Page
Loading...
