Audi A4 2015 - Page 46

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Continuation for Both Sides:
TIP:
Risk of damaging the drive axle: when lifting the engine the drive
axles must not come into contact with the suspension struts.
– Support the engine in the installation position (refer to
⇒ “2.2 Engine, Supporting in Installation Position”, page 38 )
and tension with the -10-22A/11- until the engine mount is en‐
gaged.
– Remove the bolts -arrows- and engine mount -1-.
Installing
Install in reverse order of removal and note the following:
• Replace the bolts that were tightened with an additional turn
after removing them.
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
♦ Refer to ⇒ Servicing - 4-Cylinder 1.8L; 2.0L 4V TFSI Engine;
Rep. Gr. 21 ; Charge Air System; Overview - Charge Air Hose
Connections .
♦ Ground Wire. Refer to ⇒ Wiring diagrams, Troubleshooting &
Component locations
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner;
Overview - Front Wheel Housing Liner .
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
2.3.2 Support Bearing, Removing and Instal‐
ling
Removing
– Remove the front noise insulation. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Noise Insulation, Removing
and Installing .
– Remove the bolts -1 and 3- and remove the support bearing
-2-.
Installing
Install in reverse order of removal and note the following:
• Replace the bolts that were tightened with an additional turn
after removing them.
– Note the installation position. Refer to
⇒ Fig. ““Support Bearing, Installation Position”“ , page 36 .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
40 Rep. Gr.10 - Engine Assembly