EasyManua.ls Logo

Audi A4 2015 - Page 119

Audi A4 2015
199 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
WARNING
The cooling system is under pressure when the engine is warm.
Risk of scalding due to hot steam and hot coolant.
Scalding the skin and other parts of the body is possible.
Wear safety gloves.
Wear protective eyewear.
Reduce the pressure by covering the coolant expansion tank
cap with a cloth and carefully opening it.
Open the coolant expansion tank cap -1- briefly by releasing
the catch in direction of -arrow- if necessary.
Remove the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Free up the electrical wire.
Remove the bolts -1 and 2-.
Place a cloth underneath to catch any escaping coolant.
Loosen the hose clamps -arrows-, then clamp off the coolant
hoses with the -3094- and remove the hoses.
Remove the coolant pipe.
Installing
Install in reverse order of removal and note the following:
Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
Install the engine cover. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 10 ; Engine Cover; En‐
gine Cover, Removing and Installing .
Check the coolant level. Refer to ⇒ page 99 .
Tightening Specifications
Refer to ⇒ “3.1 Overview - Coolant Pipes”, page 111
3.2.2 Right Coolant Pipe, Removing and In‐
stalling, Vehicles without Particulate Fil‐
ter
Special tools and workshop equipment required
Hose Clip Pliers - VAS6362-
Socket T30 - T10405-
Removing
During installation, all heat shield boots must be installed at
the same location.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
3. Coolant Pipes 113

Table of Contents

Other manuals for Audi A4 2015

Related product manuals