Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the bolts -arrows- and air duct -1-.
– Remove the upper air duct -arrow-.
– Remove the charge air cooler. Refer to
⇒ “2.3 Charge Air Cooler, Removing and Installing”,
page 134 .
– Disconnect the connector -2- for the High Pressure Sensor -
G65- .
CAUTION
Risk of damaging the retainers due to improper handling.
– Carefully release the retainers.
– Carefully release the left and right catches in direction of
-arrows-.
• If the catches are damaged replace the radiator.
CAUTION
Risk of Destroying the Refrigerant Lines by Tearing the Inner
Film
– Never bend the refrigerant lines to a radius smaller than r =
100 mm.
– Disengage the condenser -1- on the radiator and tie it up to
the side.
– Lift the clamps -1 and 2-, remove and free up the coolant con‐
nection from the radiator.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
122 Rep. Gr.19 - Cooling System
To Next Page
Loading...
